Type-44: pressing hub into front wheel bearing

[frank j. bauer]

i think on the front there is an inner stop machined into the housing and 
only an outer ring is used.

DON'T FORGET to mount the outer ring before you press the hub in.
not that i would ever do anything like that...

frank

At 09:55 PM 11/25/2003, Livolsi, Stephane wrote:
>Hi Ameer.  I just did a rear one on my type 44 and I think it is similar
>to the fronts.  There should be a snap ring in a groove in the hub.  The
>bearing gets pressed in until it's snug up against the snap ring, then
>the second snap ring can be put in.  Like I said, this was on the rear,
>but I am quite certain the front is the same.