Tranny removal 4kq

Denis sparkplugvw at hotmail.com
Wed Sep 10 09:47:47 EDT 2003


I did on my 100Q 1989 last week,,, the only problem was the down pipe,,, i
could pull out the tranny but with efforts..... i dont think i ll be albe to
put it back with call all my church language,,,,  so  i ll  remove the down
piep. Now without tranny i have enought room to  unbolt rusty  bolt on the
exhaust manifold. Oups, u need very  flexible human arm to  pass true all
things around.... tranny mount are tuff to unbolt (hex bolt).

Denis
100Q
5000TQ
90

----- Original Message -----
From: Huw Powell <audi at humanspeakers.com>
To: HARDISON, ROBERT TOWNSEND <HARDISOR at engr.sc.edu>
Cc: <quattro at audifans.com>
Sent: Tuesday, September 09, 2003 1:51 PM
Subject: Re: Tranny removal 4kq


>
> > Hey, Im in the process of replacing a clutch in a 4kqcs. My question
> > is, do i really need to remove the tie rods from the steering column
>
> Well, not from the "steering column," but from the bracket on the end of
> the rack, yes.  According to the Bentley, and experience, this is
> necessary to get enough clearance to pull the tranny out.  Although... I
> was watching Sean do a 90Q clutch next door (grrrr, with the tranny jack
> Nate and I couldn't figure out when we did my 87.5 cgt!), and he left
> them on and just *really* pushed up on the front of the engine to get
> clearance.
>
> --
> Huw Powell
>
> http://www.humanspeakers.com/audi
>
> http://www.humanthoughts.org/
>
>



More information about the quattro mailing list