Different dizzy gear teeth?

[Alan Pritchard]

Thanks all, I actually looked on etka and it did show the same part numbers
for the gears. Started on the swap last night, then came to a grinding stop
when I couldn't find the tdc mark on the cam gear!!!!  Granted where I was
parked in my garage gave very poor light... in the mean time I noticed the
small connection in the top of the water reservoir was broken looked like
the po had glued it on!!! That explained my loss of water over time!!!
Luckily next to my car in my garage is the 80, which has slowly been
cannabalised, shame really, quite a nice car!!! Oh well.  

Best Regards,
Alan Pritchard

Network Administrator
Mechanical Design Engineer
Seaeye Marine Ltd.
+44 (0)1329 289000

 -----Original Message-----
From: 	Huw Powell [mailto:audi at humanspeakers.com] 
Sent:	30 April 2004 06:39
To:	Alan Pritchard
Cc:	Quattro List (E-mail)
Subject:	Re: Different dizzy gear teeth?


> Just bought a schrick cam, originally fitted to a 86 4000 CS Quattro, I
plan
> on putting it in my 1990 90q (ng head, kv bottom end), then I remembered
> about the differing number of dizzy gear teeth, can anyone recall
when/what
> the differences are?

None, those two parts will mate just fine.  I've put a 4kq dizzy on an 
NF head no problem.

-- 
Huw Powell

http://www.humanspeakers.com/audi

http://www.humanthoughts.org/