SV: Exhaust flare tool?

[Jörgen Karlsson]

Hi,

I just use an adjustable wrench, a plier and a hammer to make them. I need 5
minutes to make them from scratch now. It sucks a bit to do it under the car
but that works too. You don't need to be very careful, it's pretty self
adjusting.

Jörgen

> -----Ursprungligt meddelande-----
> Från: quattro-bounces at audifans.com
> [mailto:quattro-bounces at audifans.com]För Roa, Greg
> Skickat: den 29 april 2004 15:56
> Till: quattro at audifans.com
> Ämne: Exhaust flare tool?
>
>
> Ok, my Audi question of the day:
>
> Does anyone know of a inexpensive tool or a procedure to make the
> flares for Audi exhaust pipes?  I'm talking about the flares that
> are on the joining sections (ex-between the middle and rear
> muffler sections) that use the metal donuts in-between them.  I
> need to replace the exhaust on one of my 4kq's soon, and I'd like
> to fab it myself, but I'm not sure how to do the flaring.
>
> Also, is there a good source for the three point flanges?
>
> Thanks!
>
> Greg Roa
> Cincinnati, OH
> 86' 4kcsq x2
> 87' 5kcstq
> 93' 90CS
> 83' 944
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>