Where is the engine light or plug for test engine ???? Re:

[Denis]

  How the fault code connector look like ?
  Is it a black connector with a plastic grip each side ,  with 2 pins ?

  I found one. Gree/red and black/red wirre to it.

  Ðenis
    ----- Original Message ----- 
    From: Tony Lum 
    To: Denis 
    Sent: Sunday, December 12, 2004 10:14 PM
    Subject: Re: Where is the engine light or plug for test engine ???? Re: My 100Q has no power again, , , big cow..


    At 09:56 PM 12/12/2004 -0500, you wrote:
    >i checked my diagram and i dont see a CEL on the shematic !!! i had the 
    >cEL on my ex 90.
    >
    >Ðenis

    Yes.  It is not installed in '89 Model Year.  However, if you remove the 
    instrument cluster and see empty bulb holder tied to back of harness, 
    that's the CEL.  Audi often puts connectors there that are not used.  For 
    example, on my 1985 4000 quattro, there's is not supposed to be a after run 
    circuit, but I found 2 unused pins on harness in engine compartment.  I 
    traced wires back to empty relay socket in relay panel behind driver's 
    lower dash panel.  All I had to do was to install proper after run relay 
    and install thermoswitch on bracket mounted to right rear of cylinder head 
    and I now have after run function.

    Tony