NAC- cad design question

Tom Love theloves at localaccess.com
Tue Feb 3 21:47:14 EST 2004


Yep! Tracing is what I do when it comes to importing any .jpg image into a
.dwg drawing. Then you get creative!

I am a firm believer that those who currently write the acad programs don't
know crap about what drafting really is.

Yesterday I could not even spell architect but now I are one!

My Audi content?

There is a image for relaying of the tail lights on a 4kq that was done in a
acad format floating around this group that I did quite a while back that
did take some creativity to post.



----- Original Message ----- 
From: "Zsolt" <zsolt1 at telusplanet.net>
To: "Todd Young" <auditodd at comcast.net>; "Steve R" <srosen at starxray.com>
Cc: "audi group" <quattro at audifans.com>
Sent: Tuesday, February 03, 2004 6:19 PM
Subject: Re: NAC- cad design question


> Steve,
>
> You are attempting to convert a bitmap or pixel based file into a vector
> (line) based one. Other than tracing it e.g. in Corel Trace there is
really
> no way to do that. Tracing an image like that may not work very well
> either, depending on how complex it is.
>
> This is completely different from exporting a vector based file into a
> bitmap, since all it does is takes a "picture" of your drawing at the set
> resolution.
>
> Zsolt
>
> At 03:44 PM 2/3/2004, Todd Young wrote:
> >Maybe IrfanView:
> >http://www.irfanview.com/
> >
> >Steve R wrote:
> >>Anyone now of a jpg, pdf to dxf,dwg or any cad type file conversion
> >>program. I've found programs that convert into jpegs but the reverse.
> >>Thanks in advance.
> >>Steve
>
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>




More information about the quattro mailing list