016 tranny reverse not engage + clutch sliped

[Denis Julien]

Yes.
I unscrewed a strar srew in the top of the tranny. That screw maintain a
lever and spring, whicht felt down in the case. So it took hours to put it
back, and i m not sure is the good way.

That srew screw in the steel case and in that lever.... so i dont know if
the offset is ok..... the problem is around this part, that part toggle
another small gear to go reverse.

Denis J


----- Original Message ----- 
From: "Ado Sigal" <a.sigal at bluewin.ch>
To: "Denis Julien" <sparkplugvw at hotmail.com>
Sent: Thursday, February 12, 2004 2:54 PM
Subject: Re: 016 tranny reverse not engage + clutch sliped


> At last you found the clutch problem, and would have no more problems
> there, but the box problem is still there. From your description, I
> understood that the shaft removed was on second section, and that is
> where the shift mechanism is. You have to make absolutely sure that
> every fork, lever and plunger are in their intended position. The
> problem that I've experienced, which manifested itself very much like
> yours, happened after the person removed the shaft at the end of second
> section, thinking that it was a plug where the oil can be filled
> through, without need to remove the filler plug on the side. It took
> many hours to put it back together without completely dismantling the
> box. Yours might not be the same cause, but definitely it is the
> position of shifting gear mechanism, for the problem to arise, since
> nothing was disturbed in the actual box gear bunches and main shafts, so
> you should examine carefully from the point of disturbed part, since the
> cause of the problem is definitely there.
> HTH and regards,
>
> Ado
>
> Denis Julien wrote:
>
> > Clutch slip:
> >
> > Plzzz dont tell to anyone i putted the clutck ''fork'' in wrong side so
the clutch nevr release enought in rest position ,,, so slipping :-(.
> >
> >
> > Reverse:
> >
> > i opened the last aluminium section and look at the HOW reverse and fith
works.... they are in same shaft shift.
> >
> > It goes one side to shift 5 gear but extremely hard to get into the
reverse. I got hard time to push the reverse so the problem is inside the
second section, the heavy steel box with all gears (almost)...
> >
> > to be follow tonight ;-)
> >
> > Denis Julien
> > _______________________________________________
> > quattro mailing list
> > quattro at audifans.com
> > http://www.audifans.com/mailman/listinfo/quattro
> >
> >
>
>
>