Cam/Crank shaft oit seal removal 90q 20v

[walian at att.net]

David,

  Usually the seals have metal in them you need to drill a small hole through 
the metal and then use the screw technique. Look at the new ones to determine 
where the metal is. In the past I have made something like a dent puller with 
a screw at the end. Maybe you can carefully cut a small groove in the metal 
and use a screw driver and rotate it out. Just be careful to not nick the 
cam. I know this is obvious info but hopefully it may help. Maybe some other 
listers have better techniques. 

Frank
> So far I broke 2 tips off of random knives, tried the screw technique 
> (screw pulled right out..), tried to stick a screw driver in there... 
> nothin...
> 
> I am tempted to blowtorch it and just melt the rubber away... j/k  hehhe
> 
> Akkkkkk  I am pulling out my hair...
> 
> 
> On Friday, January 16, 2004, at 04:47 PM, David Thoresen wrote:
> 
> > I have the timing belt off and everything but am having some extreme 
> > difficulty removing the seals... I unfortunately do not have the 
> > specific tool for the job... anyone have any tips??  I would greatly 
> > appreciate it very very very much...  I am trying to button up this 
> > thing tonight.
> >
> > Thanks You!
> >
> > David
> >
> > _______________________________________________
> > quattro mailing list
> > quattro at audifans.com
> > http://www.audifans.com/mailman/listinfo/quattro
> >
> 
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro