How do you tighten inner CV-joint bolts? (Type-44)

[Ado Sigal]

Ameer Antar wrote:

> I'm looking for advice or BTDT's on tightening the inner CV-joints in 
> the front of a 5kt. From the top, the engine mount brackets get in the 
> way, and from the bottom, the subframe is in the way. I was able to 
> get at a few of them by using a 12" extension, but the bit doesn't 
> stay centered as I tighten and I can't get the right torque w/ my 
> wrench (59 ft-lbs. I believe). The problem is also how to keep the 
> wheel from turning. I don't have a lift, but is that what I'll end up 
> needing? TIA.
>
> -Ameer
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>
Ameer, tighten all the bolts initially, one by one, from the accessible 
position, turning and holding the hub by the hand. For your final 
tightening, same procedure, but hold the disc against the calliper with 
grip pliers (not to heavy). The markings that it leaves are going to 
disappear after your first good stop, but if you are going to be 
particular, use a piece of leather or thin plastic strip in-between.

Regards,

Ado