How to replace Front Wheel Bearings?

[David Kavanagh]

On Thu, 17 Jun 2004 17:08:34 -0700 (PDT), James Dupree
<jdupree914 at sbcglobal.net> wrote:

> Remove large nut (or bolt) from outer CV joint where it goes thru the hub
One important thing I'd like to add here is that this bolt/nut should
be loosened and re-torqued with the car on the ground! The force
required for this nut could topple the car off the jackstands. No
fooling! Just remove the center cap and do this before raising the car
and tighten with the car on the ground at the end.

David

-- 
'00 A6 biturbo 6-speed