Does anyone make Coupe GT Fenders?

[Ti Kan]

Tyson Varosyan writes:
> I am in the process of lining up the ducks for my SCCA Rally car project
> scheduled for completion this spring. The car will be based on an Audi
> 4000CSQ, however with SCCA regulations, the tires/wheels cannot extrude past
> the fenders, even in the Open class which we plan to enter. With the
> additional power of a Turbo motor that is going to be happening here
> shortly, I would like to better use it with a wider patch of tires. The
> thought I had was to add wheel well flares like those found on the Coupe GT
> to the 4000 both front and Rear.

The Coupe GT has the same fenders as the 4000.  Perhaps you're thinking
of the flared Ur-Quattro fenders?

> The plan is to custom-make them out of
> Fiberglass, but with time being short and more pressing issues at hand (like
> getting the engine swapped) I would like to see if there is anyone out there
> that knows of a way to get ether the whole flared fender or fiberglass/steel
> flare add-ons for the car.

I don't have any pointers to add-ons, but the UrQ fenders will no doubt
be fairly expensive and cost a lot.  The front fenders will bolt-on
except that it won't line up with the stock 4K's rocker panel, so it
will require mods.  The rear flare will be more of a problem.  It will
have to be grafted onto the 4K's body and then the rear door's seam
will have to be custom cut.  That will be very labor-intensive and expensive
too.  This sort of mod has been done.  Check out the "California Quattro"
article on my site:
	http://www.amb.org/ti/audi/audi-misc/cal4kq.html

-Ti
-- 
Ti Kan
http://www.amb.org/ti
Vorsprung durch Technik