CEL @ 1.0bar

[Ti Kan]

Cody Forbes writes:
> I've had my CEL lighting up for roughly a week now any time I'm at or =
> over 1.0bar on the EFI'd '87 5ktq. IIRC this could signify a bad or =
> disconnected IAT sensor right? Any other things it might mean? It is not =
> related to the WOT switch, definately only related to pressure. Is the =
> IAT sensor used for anything on the ignition side? Since I'm running EFI =
> with a separate IAT sensor I suppose I could ditch the stock one, but =
> how can I trick the MAC-11 into not annoying me about it?

Have you tried pulling the codes first before guessing at the
source of fault?

-Ti
-- 
 R 1 3 5  Ti Kan
 |_|_|_|  http://www.amb.org/ti
   | | |  Vorsprung durch Technik
   2 4 6