RPM surge at Idle( solved)

[Ti Kan]

Brian Sims writes:
> This one is on me. The surging had some of the typical signs of an O2 =
> sensor but it never caused any codes. Turns out I caused the situation. =
> When I replace O2 sensors, I pull the pins out of the connector for the =
> heater that is anchored in the bracket because the tab holding it in, =
> usually breaks if I try to remove the connector. I got the pins mixed =
> up. Why are those wires both white?

Because it shouldn't matter which way it's hooked up, it's just a heating
filament.

-Ti
-- 
Ti Kan
http://www.amb.org/ti
Vorsprung durch Technik