FIXED - Re: Misfire on cyl. 2 & 3

[Doug Yoder]

Ok, after some more investigating, I have determined that I am an idiot.

When I installed the new distributor cap, I managed to swap the wires 
for #2 and #3.  I had carefully (not carefully enough, apparently) 
traced each wire from the plug to the dist. cap, and then marked the new 
cap to be the same way, then marked the ends of the wires to match.  So 
when I was performing all my later investigating, I was using my marks 
which I was sure were correct...

Anyway, like the subject line says, it's fixed now.  Thanks to everyone 
who helped!

-Doug, very embarrassed.
-- 
*------------------*--------------------*------------------------------*
|    Doug Yoder    |   wdy at zordok.net   |    http://www.zordok.net/    |
*------------------*--------------------*------------------------------*
|  Don't tell me the sky's the limit...                                |
|                                  ...there's footprints on the moon.  |
*----------------------------------------------------------------------*