Bearing question

[Bernard Littau]

On Tue, 29 Mar 2005 12:57:20 -0500, Kent McLean
<kentmclean at mindspring.com> wrote:
> Huw built a bushing press out of plumbing pipe and threaded
> rod. You may be able to make a similar tool for the bearing.
> 
> <http://www.humanspeakers.com/audi/bushings-pix2.htm>

I'm thinking it is unlikely you can build one of these for a front
wheel bearing removal out of plumbing and low grade parts.  In my
experience, the bushings almost fall out and only need a good nudge. 
The front wheel bearings on my 5ktq took almost everything my 20 ton
shop press had to offer.

Best,

Bernard Littau
Woodinville, WA