wheel bearings and struts (4kqcs)

[SAM LETZRING]

Done it many times in the 500 kmiles on my 86 4KCSQ

JUst disconnect the lower ball joint and there is plenty play to get the
splined shaft out of the hub

May have to play with steering a bit- but it comes right out

If you have more questions- e-mail me off-line

Sam


----- Original Message ----- 
From: "Kent McLean" <kentmclean at mindspring.com>
To: "Nolan Gilliam" <RuKsHawMasTeR at msn.com>
Cc: "Quattro list" <quattro at audifans.com>
Sent: Saturday, November 12, 2005 5:28 PM
Subject: Re: wheel bearings and struts (4kqcs)


Nolan Gilliam wrote about replacing a strut:
 > Ooops sorry yha 87 4kqcs.  The problem is I couldn’t get the
 > strut boot to sepearte from the hub and that’s the only way
 > to get enough clearance to bring the strut in and out right?

I don't know. I've CC'd the quattro list; maybe they'll
have an answer.

--
Kent McLean
'94 100 S Avant, "Moody"
'89 200 TQ, "Bad Puppy" up in smoke
_______________________________________________
quattro mailing list
quattro at audifans.com
http://www.audifans.com/mailman/listinfo/quattro