5000 Turbo engine versions

[Tony Hoffman]

The vin is: WAUHC0441FN104092. I couldn't find anything conclusive enough in the Bentley to tell me what engine this is. About three spots tell me it's an MC1, varying from 158 to 162 HP. In one other spot, it tells me that it's a 130HP turbo engine. BTW, the Bentley also says the KH is 135 hp, and 140 hp. Not real decisive. Anyhow, I didn't check for the water cooled turbo. Where is the knowk sensor on these engines? Right below the distributor, If I recall correctly. Hope that's right. I'll probably go to look closer at it tonight. I'll try the crayon trick then.
 
Tony Hoffman

Paul Cole <pcole at mn.rr.com> wrote:

What's the VIN ?

Is the factory "label" still in the trunk ( under the rear deck lid) ? It has both the 
tranny and engine codes along with most other build info.

I've seen some wire brush and good PL ( kroil, JB80 etc) bring the engine ID up 
fairly easy. Apply with elbow grease and then use a soft woodworking yellow
crayon to get the indentations to "show".
Always seems to work for me.

One "clue" is the knock sensor and water cooled K26. I don't think the KH engine
had the water cooled turbo. 


HTH

//************************
Paul R. Cole: 
'83 Urq Helios Blue ( SAR) #900335 
'91 200 TQ 20v- Daily driver @323+k!!!.
'91 Quattro Coupe - Still going @ 288k mi.- 4 older CGT's/200 TQ
Bloomington,MN pcole at mn.rr.com # Powered by OS/2 Warp 4
//---------------------------------------




		
---------------------------------
Yahoo! for Good
 Click here to donate to the Hurricane Katrina relief effort.