Need PN for sensor 88-89 80q and anyone want to send me

[Tihol Tiholov]

>To: stpndsmn at yahoo.com, quattro at audifans.com
Message-ID: <8C7F94F9D6B6961-10D4-CDC8 at MBLK-M42.sysops.aol.com>

>035919561

>That's the sender that runs the light and the gauge. Should be the same on
various models. You probably want to replace the low(or is it high?)
pressure switch too.  It screws into the block right below this sensor.

I took off my '88 90 Q, NG the OEM with the above PN plus an "A" at the
end.  It says on the nut portion "0-5 bar" and also "1.8+/- 0.2 bar".
Apparently there is more than one replacement (as mentioned by
autohausaz.com) because the new one I installed is tripping the
check/warning system display at 3K RPM with no other ill effects - normal
behavior of the oil press. gauge, driven it like that for over a year - I
know, a little sloppy...