86 5000 heater core removal

[MWoodland at Dentsply.com]

Paul,
I did a write up on removing the heater core from the engine compartment
side with a Japanese key hole saw, that cuts on the pull stroke.
Caught a bit of flack for 'hacking', but I was able to R&R the core in
under 2 hours, and didn't have to fiddle around with aligning the flaps,
etc.
I didn't have a garage, or the luxury of time, as I was commuting 1000
miles a week in an '87 5KTQ, and needed heat, "right now".
It should be in the archives, but I can't find it.. or any other posts from
me since 1999. (?)
I'll see if I have a copy at home.
Mark

---------------------------------------------------------
This message contains confidential information intended
only for the use of the addressee(s) named above and may
contain information that is legally privileged.
 If you are not the addressee, or the person responsible
for delivering it to the addressee, you are hereby notified
that reading, disseminating, distributing or copying this
message is strictly prohibited.  If you have received this
message by mistake, please immediately notify us by
replying to the message and delete the original message
immediately thereafter.  
Thank you.

Any views expressed in this message are those of the
individual sender, except where the sender specifies and
with authority, states them to be the views of DENTSPLY
INTERNATIONAL INC.
---------------------------------------------------------