Ac Q for '93 90s

[auditodd at comcast.net]

>SO I recently picked up a 90s from Vermont and just got done replacing all the front >control arm bushings, strut bearings, sway bar links, and one tie rod. So now that >I've addressed that, I need to examine the AC and see what's going on. Of course, >the only Bentley I don't have is for this car. Can anyone tell me where the low side >valve is for the AC? I understand it's 134a (like my '93 V8). Looks like things are >pretty tight with that V6 (though it does get very nice gas mileage). TIA

Good luck with that one.
The only low side port I found was on the actual compressor and it is NOT a standard port.

I usually "topped off" the R134a by heating up a can with warm water (using a thermometer so I didn't get it too hot) and then attach the can to the high side, tip upside down, and open the vavle. This dumps the freon (or oil or conditioner) into the system. Make sure the system is cold with a cold engine.
--
----
------
Todd Young