Bad fuel pump or pressure regulator shims

[Ado Sigal]

Shim kit is expensive, so could take pressure reg spring and shim 
(always one, around ! mm thick) from any CIS car, or if you stuck, could 
send you one (complete unit without the plunger), just send me your 
address. I am in Geneva, so it might take few days.

Regards,

Ado

Ameer Antar wrote:

>The only other thing I could think of is pressure regulator in the fuel distributor needs to be shimmed. I actually took it out and cleaned the regulator. It was very clean, and I noticed there are no shims. This is supposed to be a rebuilt fuel distributor, so I'm a little surprised the pressure would be off. Does anyone know where to get these pressure regulator shims?
>Any advice is much appreciated.
> 
>-Ameer 
>
>------------------------------------------------------------------------
>
>_______________________________________________
>quattro mailing list
>quattro at audifans.com
>http://www.audifans.com/mailman/listinfo/quattro
>---
>Watch this space for ads :)
>