Measuring current of CPA/R??

[Huw Powell]

> I am trying to measure the current at the control pressure
> actuator/regulator on my 85 4ktq project and I am trying to figure
> out exactly how to measure the current in series.
> 
> If I engineer a break in the positive wire and use the DMM to bridge
> the gap then would I be measuring current??

Yes, that is correct.  What we typically try to build (and what VAG 
probably sells) is a male to female "insert" with the "break" in it to 
hook up to the meter.

The pain in that is there is only one place to get the "chassis" half on 
each junkyard car, and that is the harness side of the OXS connector 
(all the other two pin AMP connectors mount this half on the device in 
question, like the CSV, etc.)

-- 
Huw Powell

http://www.humanspeakers.com/audi

http://www.humanthoughts.org/