Quick and dirty fix for hood release cable guide sleeves
Kneale Brownson
kneale at coslink.net
Sat Sep 9 21:43:10 EDT 2006
The replacement sleeves are steel, I believe. Your aluminum one will be
rubbing on steel. May not last very long.
At 05:31 PM 9/9/2006 -0700, Jim Jordan wrote:
>Hi,
>
>While fiddling around with getting replacement guide sleeves I derived a
>cheap and dirty work around that may be as good as the replacements. I got
>an aluminum screw post in the specialty section of OSH(Orchard Supply
>Hardware). It was nominally 1" long and had an OD of ~3/16", about the same
>as the small OD of the broken sleeve. I drilled through from the threaded
>end of the screw post with a 1/8" bit making a hole through the head of the
>post. Then I drilled through from the clamp side of the sleeve, the big
>end, with a bit the same size as the screw post OD, tapped the screw post
>through the head of the broken guide sleeve, and voila, a working guide
>sleeve.
>
>I used regular tools, hand drill, etc. Could be done better with a drill
>press, but then I could make them with a small lathe.
>
>I'm buying a couple just in case........
>
>Cheers!
>
>Jim Jordan
>
>_______________________________________________
>quattro mailing list
>quattro at audifans.com
>http://www.audifans.com/mailman/listinfo/quattro
>---
>Watch this space for ads :)
More information about the quattro
mailing list