Quick and dirty fix for hood release cable guide sleeves
Huw Powell
audi at humanspeakers.com
Mon Sep 11 21:06:01 EDT 2006
> While fiddling around with getting replacement guide sleeves I derived a
> cheap and dirty work around that may be as good as the replacements. I got
> an aluminum screw post in the specialty section of OSH(Orchard Supply
> Hardware). It was nominally 1" long and had an OD of ~3/16", about the same
> as the small OD of the broken sleeve. I drilled through from the threaded
> end of the screw post with a 1/8" bit making a hole through the head of the
> post. Then I drilled through from the clamp side of the sleeve, the big
> end, with a bit the same size as the screw post OD, tapped the screw post
> through the head of the broken guide sleeve, and voila, a working guide
> sleeve.
>
> I used regular tools, hand drill, etc. Could be done better with a drill
> press, but then I could make them with a small lathe.
Glad you came up with a temporary (permanent?) fix - though, wouldn't it
have been easier to just drill a hole through a bolt?
--
Huw Powell
http://www.humanspeakers.com/audi
http://www.humanthoughts.org/
More information about the quattro
mailing list