Can I retrofit fuel pump on type 44 with 43mm one?

[kbogach]

Kneale, thank you very much!  I did not think about removing whole 
support system.  But, why not?   Great!  Now I wounder how much that 
piece of plastic cost.  Do you know?   S-car piece probably should have 
roughly the same cost, I think.

Konstantine

Kneale Brownson wrote:
> The mounting systems are anchored to the bottom of the tank with nuts 
> on studs.  I think 10 mm.  You can take the older system out and 
> install one from a 1991 and then install the smaller diameter pump 
> with the sleeve as described on Chris's website.  When I installed a 
> S-Car tank in my 200q20v, I had to change the base mountings in order 
> to use the 200 smaller sleeve and pump because the S-car base mounting 
> had a different structure where the pump sleeve fits.  You can see 
> the fixture attached to the bottom of the tank in my image at  
> http://www.pbase.com/kneale_brownson/image/30210145   
>
> */kbogach <kbogach at comcast.net>/* wrote:
>
>     My 200tqa has older 3 legs support system, info on Chris Miller's
>     site
>     does not apply in this case, I believe. So far, I replaced mine with
>     used one from junk yard twice. All three were humming. Could it be
>     that the problem is somewhere else? All pressures tests are fine
>     though. Anyway, it would be nice to retrofit smaller pump - it cost
>     less and quieter.
>
>     Thanks in advance,
>     Konstantine
>     _______________________________________________
>     quattro mailing list
>     quattro at audifans.com
>     http://www.audifans.com/mailman/listinfo/quattro
>     ---
>     Watch this space for ads :)
>
>