Can I retrofit fuel pump on type 44 with 43mm one?

[Kneale Brownson]

The mounting systems are anchored to the bottom of the tank with nuts on studs.  I think 10 mm.  You can take the older system out and install one from a 1991 and then install the smaller diameter pump with the sleeve as described on Chris's website.  When I installed a S-Car tank in my 200q20v, I had to change the base mountings in order to use the 200 smaller sleeve and pump because the S-car base mounting had a different structure where the pump sleeve fits.  You can see the fixture attached to the bottom of the tank in my image at  http://www.pbase.com/kneale_brownson/image/30210145    

kbogach <kbogach at comcast.net> wrote:  My 200tqa has older 3 legs support system, info on Chris Miller's site 
does not apply in this case, I believe. So far, I replaced mine with 
used one from junk yard twice. All three were humming. Could it be 
that the problem is somewhere else? All pressures tests are fine 
though. Anyway, it would be nice to retrofit smaller pump - it cost 
less and quieter.

Thanks in advance,
Konstantine
_______________________________________________
quattro mailing list
quattro at audifans.com
http://www.audifans.com/mailman/listinfo/quattro
---
Watch this space for ads :)