3B to AAN conversion and vice versa.

[Ben Swann]

Well there are a lot of reasons.  Mainly I want to use the AAN engine management on a 3B
engine that has RS2 induction.  Basically building an RS2 engine.

I was going to use the AAN engine until I aquired a seriously built 3B - Pauter Rods, JE
Pistons, balanced, etc.  Head nicely reworked.

Might be easier for me to swap heads, since the head work can be fairly easily
replicated, but a lot of money and machine work went into the bottom end.

Much more to this insanity, but that is the basic explanation.

Ben

-----Original Message-----
From: Huw Powell [mailto:audi at humanspeakers.com] 
Sent: Tuesday, June 17, 2008 10:26 PM
To: Ben Swann
Cc: s-car-list at audifans.com; '200q20V mailing list'; quattro at audifans.com
Subject: Re: 3B to AAN conversion and vice versa.


> Don’t ask why – just need to convert an AAN block and head to 3B setup and a 3B to an
> AAN. 

Why?

-- 
Huw Powell

http://www.humanspeakers.com/audi

http://www.humanthoughts.org/