3B to AAN conversion and vice versa.

[pdooley]

I think Huw was being facetious, 
but good explanation none-the-less.


-----Original Message-----
From: quattro-bounces at audifans.com [mailto:quattro-bounces at audifans.com] On
Behalf Of Ben Swann
Sent: Tuesday, June 17, 2008 11:35 PM
To: audi at humanspeakers.com
Cc: quattro at audifans.com; s-car-list at audifans.com; '200q20V mailing list'
Subject: RE: 3B to AAN conversion and vice versa.

Well there are a lot of reasons.  Mainly I want to use the AAN engine
management on a 3B
engine that has RS2 induction.  Basically building an RS2 engine.

I was going to use the AAN engine until I aquired a seriously built 3B -
Pauter Rods, JE
Pistons, balanced, etc.  Head nicely reworked.

Might be easier for me to swap heads, since the head work can be fairly
easily
replicated, but a lot of money and machine work went into the bottom end.

Much more to this insanity, but that is the basic explanation.

Ben

-----Original Message-----
From: Huw Powell [mailto:audi at humanspeakers.com] 
Sent: Tuesday, June 17, 2008 10:26 PM
To: Ben Swann
Cc: s-car-list at audifans.com; '200q20V mailing list'; quattro at audifans.com
Subject: Re: 3B to AAN conversion and vice versa.


> Don't ask why - just need to convert an AAN block and head to 3B setup and
a 3B to an
> AAN. 

Why?

-- 
Huw Powell

http://www.humanspeakers.com/audi

http://www.humanthoughts.org/

_______________________________________________
quattro mailing list
quattro at audifans.com
http://www.audifans.com/mailman/listinfo/quattro
---
Watch this space for ads :)