Rekeying Audi 200 Ignition Lock
Joshua Van Tol
josh at spiny.com
Fri Aug 20 05:57:41 PDT 2010
If you're talking about disassembling the lock assembly, you simply need to
drive out the roll pin that holds the part on the end that turns the
ignition lock. Don't drive it all the way out just enough to release it from
the tab, that way, it'll be easier to re-install. Then insert the key, and
remove the tumbler with the key still in it. Easy.
Josh
On Thu, Aug 19, 2010 at 11:03 PM, Paul Caouette <paxnobis at gmail.com> wrote:
> OK! So I finally got the replacement ignition lock and I'm looking for some
> way to slide the tumbler assembly out so I can set the tumblers to match
> all
> the other locks on the car....
>
> Has anyone BTDT?
>
> There must be a trick to it that I'm too feeble to determine.
>
> Thanks in Advance
>
> --
> Paul Caouette
> 1991 200 20V TQ Avant, 1998 A4 Avant, and sv Wild Iris (V40-133)
> _______________________________________________
> quattro mailing list
> http://www.audifans.com/mailman/listinfo/quattro
> http://www.audifans.com/kb/List_information
>
More information about the quattro
mailing list