Dead End on Ignition Switch Replacement
Eric Huppert
ehuppert at hvc.rr.com
Fri Jul 23 15:01:24 PDT 2010
Paul,
Thought I had done a write up, but unable to find it, so..
You're going to have to pull the instrument cluster out as the two set
screws for the switch are accessed from the top. The IC can be removed
without pulling the steering wheel, btdt many times. Take your time getting
it (IC) past the lower wood trim so it doesn't get dinked.
The screws will have some orange sealant in the holes, gently scrape it out.
Believe I used a small jewelers type screwdriver as the screws are small.
(small mirror useful as you can't look straight down due to dashpad, etc) Do
NOT remove the set screws, loosen just enough so switch will slide out.
Hopefully the tail on your ign tumbler assy is good, if not you will be
feeling LOTS of pain!
Let me know if further clarification needed..
Eric
More information about the quattro
mailing list