Replaced Sensor, ABS Light Still On
Mark Rosenkrantz
speedracer.mark at gmail.com
Tue Mar 16 09:56:25 PDT 2010
I'd look at the output with an oscilloscope. This code can actually be a
lot of things. Odds are, it's related to the axle change since that is when
it started. Something got damaged or bent... unless the tone ring isn't
correct on the replacement axle.
Mark Rosenkrantz
On Tue, Mar 16, 2010 at 10:45 AM, mkb <mkb125 at yahoo.com> wrote:
> Ok folks, I've got another issue with my 99 A6 28q.
>
> After I changed the axles on it way back when, the ABS light came on. I
> finally decided to check what the code was, and it seemed simple enough:
> 00283 - Front Left ABS Wheel Speed Sensor (G47) 30-10 0 Open or Short to B+
> - Intermittent.
>
> Googled a bit to see others have thought about this and came across this
> nice writeup:
>
> http://www.audipages.com/Tech_Articles/susp_whls_brake_steer/abstroubleshooting.html
>
> Basically, when I drive and turn the wheel the ABS light comes on which the
> writeup mentions as a symptom. After pulling the old sensor, cleaning out
> the hole the sensor fits in, I installed a new sensor which I bought from
> ebay. But...the light still came on after driving just a short way.
>
> Checked the code and got the same code. So, three thoughts come to mind:
>
> 1. Either I got a bad sensor - anyway to check?
> 2. The short is somewhere else - any ideas?
> 3. Sensor is not all the way in - I'm pretty sure it is, but I'll check
> again to make sure it is
>
> Any words of wisdom?
>
> --
> mohammed
> 99 A6 28qa
> 97 A4 18tqa
>
>
>
> _______________________________________________
> quattro mailing list
> http://www.audifans.com/mailman/listinfo/quattro
> http://www.audifans.com/kb/List_information
>
More information about the quattro
mailing list