Replaced Sensor, ABS Light Still On

[Tony Hoffman]

That's sort of what I was thinking. I just did a repair on a truck
that had worn a spot in the cable from the sensor. If youturned the
wheel one way, it was fine. The other way, the light would come on and
a code was stored.

I'd be checking that over pretty good. You may even have a broken wire
inside the insulation, so you may want to ohm it out while bending and
wiggling it.

Tony


On Tue, Mar 16, 2010 at 1:40 PM, Gerard <gerard at 2226.co.za> wrote:
> Perhaps it is the wiring going from the sensor plug through the fender
> well, etc. I recall some had issues like this before on the older 200
> and that that issue wasn't much fun to track down.