High Pressure Hydraulic Hose

[Huw Powell]

Somehow I doubt a single hose clamp is going to be sufficient to replace 
what was a very high pressure swaged fitting.  Be careful.

On 9/25/2010 10:20 PM, Max Hoepli wrote:
> Hi all,
>
>
>
> I just changed my low pressure hose, the hose from reservoir to pump using a
> "Dayco Abrasion King PUSH-ON 710-50 /8<15.5>  3000PSI MAX WP MSHA IC-123/10
> MADE IN USA 010808C". I just arrived home after having driven 170km and the
> end of the high pressure hose that pumps to the rack at the pump end came
> off. Oil squirted onto driveway. It is a banjo fitting to pump. The hose is
> around a 8mm inner metal tube; and around the hose end a 20mm outer metal
> tube. I cut off the 20mm end and am going to use a hose clamp around the
> hose and inner tube. I think if I use a 6mm wide hose clamp to bind end of
> hose to banjo ending should suffice. The hose looks in good shape.
>
>
>
>
>
> Patient:  1986 type 44 Turbo Quattro, 310,000km
>
>
>
>
>
> Max
>
> _______________________________________________
> quattro mailing list
> http://www.audifans.com/mailman/listinfo/quattro
> http://www.audifans.com/kb/List_information
>

-- 
Huw Powell

http://www.humanspeakers.com/audi

http://www.humanthoughts.org/