tranny bearing noisy

[Denis]

I did yesterday.
I saw the big C clip and the metal rubber cover, 1.5 inch approx. I removed
it and all a see its a shaft inside. What else i can do ? to  remove bearing
? big rubber around the flange, no allen bolt on the flaange.

thanks
Densi

----- Original Message -----
From: james accordino <ssgacc at yahoo.com>
To: Denis J <sparkplugvw at hotmail.com>
Sent: Thursday, August 21, 2003 7:50 PM
Subject: Re: tranny bearing noisy


> No puller on the bearing.  It's not in that tight.  A
> large snap ring holds it in place.  I used a 2x4 under
> the back of the oil pan to hold the engine up.  I
> found that letting it sag down alittle made it easier
> to reinstall the trans.  I used Redline brand syn.
> trans lube.  75w90 I believe.  It's on their website.
> I think you have the slave cylinder that's held in by
> a roll pin.  My 89 is pinned by a small bolt and it
> came out easy.
>
> Jim
>
> --- Denis J <sparkplugvw at hotmail.com> wrote:
>
> ---------------------------------
>
> Ok thanks.
>
> And for the bearing (the one plug to the driving
> shaft) do i need a puller ? i mean a special one ? or
> a general puller ?
>
> The engine is supported with tranny support, so i have
> to use a beam between fenders to support it,, u did
> that proably too.
>
> One last thing... hydrolique hose for the clutch. I
> dont know how to remove it, i dont see well how to
> remove the clutch cylinder to avoid unplug the fluide.
> i ll try it again after donner tonight.
>
> I have two Quattro tranny to practice ;-), one bad to
> replace with the good one, the one i have to change
> output bearing and by the way the seals.
>
> oups,,, the fluide... we have cold winters here so i
> ll hapy to go to synthec oil.... but i did not look at
> what brand,,, did u use facory oil ?
>
>
>
> thanks again
>
> Denis
>
>
>
>
>
>
>
>
>
>
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! SiteBuilder - Free, easy-to-use web site design software
> http://sitebuilder.yahoo.com
>