CGT / 4000 questions

[Woodland, Mark]

Greetings folks,
I'm troubleshooting an '83 CGT 5 cyl /5-speed cold start circuit.
Per the Bentley, the Coolant Temp switch "seems" to check out on the back of the head (35 Ohms vs 60).
I have continuity on the ground circuit, but the "hot" wire shared with the ignition / starter circuit is not hot, but the starter is.

Bentley schematic says they circuits are connected "behind the dash" at Terminal T4.

1. Anyone have any idea where this "T4" terminal is? The 4000 schematic shows the same terminal and circuit, if that helps.

Also, the speedo cable(s) and intermediate O2 sensor mileage recording "box" w/reset button is toast.. all rusted up.

2. Does anyone know if there is a single cable replacement that bypasses the mileage box and goes straight from the transmission to the speedo?
I would think that earlier Foxes / Quantums / Dashers might have a one piece cable.

3. Looking for CGT side trim, both sides, if anyone has any to spare.

Many thanks in advance,
Mark



This message contains confidential information intended only for the use of the addressee(s) named above and may contain information that is legally privileged. If you are not the addressee, or the person responsible for delivering it to the addressee, you are hereby notified that reading, disseminating, distributing or copying this message is strictly prohibited. If you have received this message by mistake, please immediately notify us by replying to the message and delete the original message immediately thereafter. Any views expressed in this message are those of the individual sender, except where the sender specifies and with authority, states them to be the views of DENTSPLY INTERNATIONAL INC.