Coupe GT & NLA Audi parts

[Cody Forbes]

I actually have access to vulcanization equipment, but the problem is the metal dies required. I don't think urethane would do well in the heat of an engine bay, you need rubber or silicone. Silicone would need internal cloth matrix support or it would crack quickly. 

-Cody Forbes (mobile)

> On Dec 24, 2015, at 3:09 PM, Eric Sanborn <esanborn at gmail.com> wrote:
> 
> Maybe pick 3 lotto. I figure a couple hundred bucks.  Far less if you didn't have to experiment with durometer.   Look at www.freemansupply.com or www.smooth-on.com.
> 
> On Dec 24, 2015 11:29 AM, "Cody Forbes" <cody at 5000tq.com> wrote:
> >
> > It'll take one of us winning the lotto before that happens ;-)
> >
> > -Cody Forbes (mobile)
> >
> > On Dec 24, 2015, at 10:21 AM, Eric Sanborn <esanborn at gmail.com> wrote:
> >
> >> That is where the urethane molding comes in.
> >>