Coupe GT & NLA Audi parts

[Eric Sanborn]

Cast urethane is good up to 350F if you choose the right grade. Plenty for
an intake boot.
On Dec 24, 2015 4:10 PM, "Cody Forbes" <cody at 5000tq.com> wrote:

> I actually have access to vulcanization equipment, but the problem is the
> metal dies required. I don't think urethane would do well in the heat of an
> engine bay, you need rubber or silicone. Silicone would need internal cloth
> matrix support or it would crack quickly.
>
> -Cody Forbes (mobile)
>
> On Dec 24, 2015, at 3:09 PM, Eric Sanborn <esanborn at gmail.com> wrote:
>
> Maybe pick 3 lotto. I figure a couple hundred bucks.  Far less if you
> didn't have to experiment with durometer.   Look at www.freemansupply.com
> or www.smooth-on.com.
>
> On Dec 24, 2015 11:29 AM, "Cody Forbes" <cody at 5000tq.com> wrote:
> >
> > It'll take one of us winning the lotto before that happens ;-)
> >
> > -Cody Forbes (mobile)
> >
> > On Dec 24, 2015, at 10:21 AM, Eric Sanborn <esanborn at gmail.com> wrote:
> >
> >> That is where the urethane molding comes in.
> >>
>
>