[s-cars] MTM chip wastegate adjustment

bob.rossato at att.net bob.rossato at att.net
Wed Aug 14 16:50:03 EDT 2002


> -Screw a machine or wood screw about a 1/4 inch into the hole.  (there is
> apprx. 3/8 inch of clearance from cap to hex head of adj. screw)
>

This was most definitely not the case with the cap on Paul's wastegate. Whe=
n the drill broke through the disc you could not see a separation line betw=
een the disc and the adj. screw.  They were that close.  I'm sure the disc =
deflected down somewhat but not that much.  Sounds like this will vary from=
 unit to unit.

Bob



More information about the S-car-list mailing list