[s-cars] Stumbling at low rpm

[Bob Rossato]

Or you could easily just drill a hole in the pads to accommodate the sensor.
Just use your stock pads as a guide.

Bob

> -----Original Message-----
> From: s-car-list-admin at audifans.com
> [mailto:s-car-list-admin at audifans.com]On Behalf Of Lee Levitt
> Sent: Monday, December 23, 2002 11:28 AM
> To: Rob Pecsar
> Cc: s-car-list at audifans.com
> Subject: RE: RE : [s-cars] Stumbling at low rpm
>
>
> Rob,
>
> I recently upgraded too, and I picked up a set of Porsche
> sensors, connected
> them to the leftover pigtails from the old Audi brake pads. I then found
> that some Porsche pads do not have a fitting for the sensor.
>
> For instance...
> 	Mintex Reds do
> 	Hawk HPS do not
>
> I ran the Mintex Reds briefly, then switched over to the Hawks. Had to zip
> tie the wiring up out of the way...will probably remove it soon.
>
> So, before you go to the trouble if integrating the Porsche sensors, find
> out if your selected pads can take them...
>
> Lee
> '95.5 S6 avant
> '96 A6 quattro avant
>