[s-cars] PS Pump seal kit & tighten

[Peter Schulz]

Fred:

  An easier solution is to go to a NAPA auto parts store and ask for a
11/16 inch, 3/8 drive drag link socket.  Fits like a charm.

-Peter

At 08:26 PM 5/3/2002 -0400, Fred Munro wrote:
>A drag link socket from Sears, Dan. It looks like a bit flat screwdriver bit
>with a 3/8" (or 1/2" depending on the size) square drive. You have to grind
>the edges a bit to get it to fit the slot in the X screw.
>
>Fred Munro
>'94 S4
>
>----- Original Message -----
>From: "Daniel Hussey" <dan at s-cars.org>
>To: <s-car-list at audifans.com>
>Sent: Friday, May 03, 2002 1:55 AM
>Subject: [s-cars] PS Pump seal kit & tighten
>
>
>Well, my PS pump is finally starting to piss fluid.  At idle I can watchis
>foam up (very gradually) out of the top plug.  Time for new seals...  which
>I have on order.  But, my question is...  in the meantime, what can I use
>(looks like a big flat, thick phillips head screw) to tighten down these
>plugs???  What works?  Any tools I can get at Sears that fit this thing or
>is there even a specialty Audi tool???

Peter Schulz
1990 CQ
1991 200 20v TQW indigo mica
1991 200 20v TQW titanium grey
Chelmsford, MA USA
peschulz at cisco.com