[s-cars] Upgraded brake question

[Philip Mische]

Hoppen sells the S6 Plus setup with 314mm rotors, but not cross-drilled so
far as I know.  You may want to give them a buzz.

Phil

----- Original Message -----
From: "Richard Tanimura" <Richard at Tanimuras.com>
To: <ttopley at sympatico.ca>; "audi S-cars" <s-car-list at audifans.com>
Sent: Friday, October 04, 2002 12:52 PM
Subject: RE: [s-cars] Upgraded brake question


> Trevor,
>
> I am not 100% sure but I think you might have a mix and match brake set
up.
> 315 mm diameter is not a size I recognize from Porsche. 299mm and 322mm,
> 340mm and 380mm are Porsche sizes. Could it be the you have Audi rotors?
> What kind of hubs do you have? Porsche hubs are 130 mm x 5.
>
> The brake pads are easier. Pull a pad and take to your Porsche dealer.
>
> Rich
>
> -----Original Message-----snip
> From: s-car-list-admin at audifans.com
> [mailto:s-car-list-admin at audifans.com]On Behalf Of Trevor Topley
>
> The time has arrived to do some work on those front brakes and I'm not
> sure what they are from and what pads would work best. The rotors are
> 315mm dia. and now worn to 29.2mm thick, so probably started at 30mm;
> they are cross drilled so I'm thinking they would have to be ground
> rather than turned to cure a slight vibration.
> The original 16in wheels fit over ok.
> What discs are they if I need to replace?
>
> ------------
>
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list