[s-cars] Euro/HID Upgrade for '95 S6
Aaron
aaront at cox-internet.com
Wed Aug 27 09:57:13 EDT 2003
--
[ Picked text/plain from multipart/alternative ]
I used some 3M VHB (very high bond) 2 sided tape and stuck the ballast's
behind the turn signals on both sides.
Otherwise its a snap but read the link on light / lens removal.
Aaron
Lee Levitt wrote:
>
>Chris writes:
>
>>I received my HID upgrade today and my Euros are arriving on
>>Thursday so I am
>>all set to do a Euro/HID upgrade on my Avant this Labor Day weekend.
>>
>>Besides following the included instructions, any feedback about component
>>location and installation problems and ways around them would be greatly
>>appreciated. A link to a write-up on the web would also be great!
>>
>>I'll let everyone know how everything turns out.
>>
>
>Nice upgrade. Check www.urs4.com for details on how to remove the existing
>lights. The first one will take you an hour, the second one maybe 10
>minutes. Two little gotchas - removing the trim piece under the lamp
>(written up nicely) and undoing the connector. Just squeeze the wire
>retainer and then pull off the connector.
>
>WRT the HIDs...only issue I had was finding places to install the ballasts.
>On the passenger side, I mounted the balast directly under the lamp, and
>slightly behind it. On the driver's side, I tucked it into the fender behind
>the turn signal.
>
>HTH,
>
>Lee
>'95.5 S6 avant (euros/HIDs)
>'96 A6 quattro avant (euros)
>
>_______________________________________________
>S-CAR-List mailing list
>S-CAR-List at audifans.com
>http://www.audifans.com/mailman/listinfo/s-car-list
>
--
More information about the S-car-list
mailing list