[s-cars] 3b flywheels

[Bob DG]

3B flywheel WILL NOT work with S4/6, Won't match up with the crankshaft.
BTTT






>From: Steve Eiche <seiche at shadetreesoftware.com>
>To: saltinot at alltel.net, s-car-list at audifans.com
>Subject: Re: [s-cars] 3b flywheels
>Date: Thu, 06 Mar 2003 20:14:53 -0700
>
>Tom,
>Just about any Audi flywheel with work with an AAN. Yes, the timing pins
>are in the right places comparing the flywheel used on 3B '91 200qs with
>the flywheel from an AAN car.  BUT, he flywheel needs to match the
>transmission.  The 3B flywheel will ONLY work with an 016 type
>transmission, not the O1E like the ur S4/S6, etc.  The 016 transmission
>cars have the pilot bearing in the crankshaft, whereas the 01E/01A cars
>have the pilot bearing in the flywheel.  Does this make sense?
>
>If you want a lighter solid flywheel for an 01E transmission, get a
>'90-'91 CQ flywheel and have it lightened, or get one of the aluminum
>01E flywheels that were modelled after the CQ flywheel.  There are few
>vendors for these I believe.
>
>HTH!
>
>Steve
>
>
>Does anyone know if you can run the 3B flywheel with an AAN?  Does the
>3B flywheel have the correct marks for the timing and speed sensors?
>
>What clutch offerings are there for this setup?
>
>Tom
>
>_______________________________________________
>S-CAR-List mailing list
>S-CAR-List at audifans.com
>http://www.audifans.com/mailman/listinfo/s-car-list


_________________________________________________________________
MSN 8 with e-mail virus protection service: 2 months FREE*
http://join.msn.com/?page=features/virus