[s-cars] Crank seal tool #3203 (timing belt job)

motogo1 motogo1 at cox.net
Sun May 4 12:22:05 EDT 2003


Bill, I cranked it in pretty tight. Locked the inner and outer with the set
screw, and then tightened it a bit with a wrench.   Good luck..

Gary

----- Original Message -----
From: "William Perron" <w_perron at yahoo.com>
To: <s-car-list at audifans.com>
Sent: Saturday, May 03, 2003 4:17 PM
Subject: [s-cars] Crank seal tool #3203 (timing belt job)


> S-car fans,
> Started on the timing belt job this afternoon.  Rented
> the tools from Chris at Force5, and reviewed Fred's
> procedure at urs4.com.  Job is going pretty smoothly
> so far.  I have gotten everything apart and am now
> trying to get the crank seal out using the #3203 tool.
>  I guess my question is how far do you thread the
> outer portion of the tool into the crank seal?  I have
> been backing out the center section, and threading the
> outer portion into the seal as far as it will go
> without using a whole lot of force.  Then I thread in
> the center section, but every time it just seems to
> thread in and pop the outer portion of the tool out,
> and the seal stays put.  Any advice?
>
> Thanks,
> Bill Perron
> '95.5 S6 Avant
> '85 4kq
>
>
> __________________________________
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo.
> http://search.yahoo.com
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list





More information about the S-car-list mailing list