[s-cars] Replacing my front bearings, do I need an alignment after?

Igor Kessel kbattpo at verizon.net
Wed Apr 14 19:07:06 EDT 2004


Mike Sylvester wrote:
> You don't need the kit unless you damaged the old bolt.

Sorry, Mike. Yes you do. These bolts are not reusable. Next time around 
align the new one with the old one at one end and observe that the 
cumulative error at the opposite need will be about half the thread 
pitch. These bolts stretch just like the head bolts.

> You also don't need an alignment.  Removing and reinstalling the strut housing will not make any changes to the alignment.

Sorry again, Mike. Once you remove the strut housing you will mess up 
the Camber.
However removing and reinstalling the strut housing is not needed at all 
if you use the special bearing tool as I did in January courtesy of our 
fellow lister and an all around great guy Mark Pollan.

-- 
Igor Kessel
two turbo quattros in the stable,
the third one is in the works


More information about the S-CAR-List mailing list