[s-cars] Brake-wear sensors

[Bob Frizzell]

Tim, Tom, S-men,
Thank you. I see where the wires are and go
Bob

----- Original Message -----
From: "Tim Leonard" <nard1 at voyager.net>
To: "Bob Frizzell" <bobfrizzell at shaw.ca>; <s-car-list at audifans.com>
Sent: Tuesday, January 13, 2004 2:34 PM
Subject: Re: [s-cars] Brake-wear sensors


> The first connection back from the pads is in the engine compartment rear
> corners (each side) on the fenderwell. When unplugged you will find two
male
> round terminals about 1/8" diameter in a round molded plug about 1/2"
> diameter. There also should be a holder that the connector snaps into. I
am
> assuming you have seen the hole in the fenderwell where the wire once came
> through to the pads? The connection is near this on the inner side of the
> fenderwell.
> Best,
> Tim Leonard
> ESCARGO
> Michigan
> ----- Original Message -----
> From: "Bob Frizzell" <bobfrizzell at shaw.ca>
> To: <s-car-list at audifans.com>
> Sent: Tuesday, January 13, 2004 2:40 PM
> Subject: [s-cars] Brake-wear sensors
>
>
> > S-men,
> > The previous owner of my 93 S4 put on front brake pads without the
> sensors, in fact the wiring for the sensors has been removed.  I can't
seem
> to locate the route for the wiring and don't easily have another car to
look
> at.  I know how it attaches to the brakes but where does it attach in the
> engine compartment?  Are there any sites with pictures? Any help greatly
> appreciated.
> > Bob
> > 93 Canucky S4
> > _______________________________________________
> > S-CAR-List mailing list
> > S-CAR-List at audifans.com
> > http://www.audifans.com/mailman/listinfo/s-car-list
> >
>