[s-cars] Brake-wear sensors

[Tim Leonard]

The first connection back from the pads is in the engine compartment rear
corners (each side) on the fenderwell. When unplugged you will find two male
round terminals about 1/8" diameter in a round molded plug about 1/2"
diameter. There also should be a holder that the connector snaps into. I am
assuming you have seen the hole in the fenderwell where the wire once came
through to the pads? The connection is near this on the inner side of the
fenderwell.
Best,
Tim Leonard
ESCARGO
Michigan
----- Original Message ----- 
From: "Bob Frizzell" <bobfrizzell at shaw.ca>
To: <s-car-list at audifans.com>
Sent: Tuesday, January 13, 2004 2:40 PM
Subject: [s-cars] Brake-wear sensors


> S-men,
> The previous owner of my 93 S4 put on front brake pads without the
sensors, in fact the wiring for the sensors has been removed.  I can't seem
to locate the route for the wiring and don't easily have another car to look
at.  I know how it attaches to the brakes but where does it attach in the
engine compartment?  Are there any sites with pictures? Any help greatly
appreciated.
> Bob
> 93 Canucky S4
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>