[s-cars] S4 Won't Start

[Gabriel Caldwell]

A failed cam position sensor can cause a no start, but I am not sure if
you would be able to push start with a failed CPS.  Start by replacing
the ignition switch as a diagnostic procedure.  It's cheap and easy.

Gabriel Caldwell


-----Original Message-----
From: Karl N. Matthias [mailto:karmat at matthias.org] 
Sent: July 20, 2004 11:52 AM
To: Bill Mahoney
Cc: s-car-list at audifans.com
Subject: Re: [s-cars] S4 Won't Start

Bill,

Hadn't thought of the possibility of the ignition switch itself being
the
culprit.  A search on THAT returned a fair number of results, one of
which
was:

http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/ReplacingTheIgnition
Switch

Seems like I'll investigate the starter a little and then head down the
ignition switch route.  Anyone else had a similar problem which WASN'T
the
ignition switch?  Thanks

Karl

> Karl bummed ~
>
> ".S4 won't start, but the battery is fine, the key turns in the
> ignition, and I push-started it to get it home and that all went fine.
> There is no noise at all from the starter, no click from the solenoid,
>
> nothing.  ."
>
>
>
> Karl,
>
> IME this sounds like the guaranteed to fail eventually ignition
switch,
> unbeknownst to you, remained in the start position, thus causing the
> starter to fail.
>
> Solution is a new ignition switch ($35+/-) new /rebuilt starter
($135??)
> and a couple hours repair time, okay maybe three first time thru.
>
> There is a nice write up or two or three somewhere on this.. but I
> forget where.  Search again or I'm sure some smart soul can post a
link.
>
> HTH
>
> Bill m
>
>
>
>

_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list