[s-cars] DIY FMIC - Almost done, hit a small snag

[Dave Forgie]

Gary: You da man (if you can bring this in for about US$600).  While I have am not keen on having to trim (hack) my bumper support to do a FMIC, it may not be possible to do my "'bent" vertical flow FMIC without some trimming.  With 6 inch high vertical flow (Spearco) cores and say 3" top and bottom tanks, I am still looking at 12" high.  Even with the "bend" in the vertical flow core, this is a lot.  I haven't finished the cardboard mock-up that was started last week so I don't know the answer.  In the mean time, your answer looks VERY attractive cost-wise.  Do you think there is any chance of welding extra bumper reinforcement on the outside of the bumper support to compensate for the metal that you had to trim away?

Dave F.


This e-mail and its attachments are intended solely for the person or entity
to which it is addressed and may contain confidential and/or privileged  
information.  Any review, dissemination, copying, printing or other use of  
this e-mail by persons or entities other than the addressee is prohibited   
If you have received this e-mail in error, please contact the sender  
immediately and delete the material from any computer.