[s-cars] Attempted Translations from Garrett to KKK Speak

[Mihnea Cotet]

Mike, I do have 2 RS2 hybrids with K2672 cold sides on them, I'll open one 
of them up and measure it ASAP!


Cheers,

Mihnea

At 23:25 18/03/2004 -0700, you wrote:
>Does anyone have a KKK Rs2 turbo sitting about out on a garage shelf and
>a good electronic or mechanical caliper handy by chance?
>
>If "trim" is a function of inducer diam^2 / exducer diam^2 x 100, then,
>ignoring blade counts & shapes etc. where does the K26/RS2 wheel fit in
>the following table?
>
>             Minor      Major    MinDiam^2 /
>Turbo       diameter  diameter  MajDiam^2
>_______     ______    ______    = "Trim"__
>T3-35           1.396       2.367     34.8%
>T3-40           1.484       2.367     39.3%
>T3-45           1.595       2.367     45.4%
>
>K24/ mm     @42.3mm   @60.5     48.9%
>K24 inches  1.665           2.382
>
>T3-50   1.674       2.367     50.0%
>T3-55           1.760       2.367     55.3%
>T3-60           1.830       2.367     59.8%
>
>T3-Super    1.900     2.367     64.4%
>   60
>************ TO4E Compressors *********
>TO4E-40     1.870    2.950      40.2%
>To4E-46     2.003    2.950      46.1%
>TO4e-50     2.122    3.000      50.0%
>TO4E-54     2.170    2.950      54.1%
>To4E-57     2.230    2.950      57.1%
>TO4E-60     2.290    2.950      60.3%
>
>Mike "just trying to fill in some of the gaps" P
>
>PS as long as you have the RS2 compressor wheel out naked on the table,
>how many blades are there?  How tall is the wheel too.
>
>
>
>_______________________________________________
>S-CAR-List mailing list
>S-CAR-List at audifans.com
>http://www.audifans.com/mailman/listinfo/s-car-list